DESCRIPTION
The ALTEC LANSING Model 15515A Input Bridging Transformer is a line level transformer designed to "bridge" a low impedance source to a high impedance input while providing full transformer isolation. The transformer is internally mounted on a small printed circuit board to which optional resistors forming a resistive pad may be installed. This provides a convenier.t mounting location for a pad should one be necessary and the snap-a-part case facilitates installation. Tables of pre-calculated resistor values for typical losses are also provided. The plug-in transformer is an accessory for use with all Anniversary Series power amplifier products.

SPECIFICATIONS

(Note: 0 dBu = 0.775 V rms)
Recommended Driving
Source Impedance: <600fl
Recommended Load Impedance: >15 ki2
Turns Ratio (primary:secondary): 1:1
Impedance Ratio (primary/secondary): 15 kS1/15 kS2
Nominal Primary
Impedance: 15 kS2 (Ref. 1 kHz,
secondary terminated with 15 kf2load)
Maximum Input Level: + 18 dBu (6.16 V rms) (Ref. 20 Hz, 1%THD)
Total Harmonic Distortion
(below saturation):
20 Hz: <0.1%
1 kHr. <0.01%