Altec Lansing Industrial Professional Sound Products Spec site

ALTEC LANSING INDUSTRIAL PROFESSIONAL SOUND PRODUCTS AMPLIFIER ACCESSORY LIST

aLTEC aMPLIFIER aCCESSORIES SECTION

 

 

CLICK ON ANY IMAGE TO VIEW THAT EQUIPMENT SECTION

 

15581A Electronic Frequency Dividing Module

page 2

 

<< Previous
Amp Accessories 1697B Passive Monitor Panel pg2

Gain: Unity
Output Type: Unbalanced Output Impedance: < 100 ohms
Minimum Load
Impedance: 2000 ohms
Maximum Output
Level: +18 dBu

Total Harmonic
Distortion: < 0.01% at 0 dBu over full bandwidth
Intermodulation
Distortion(SMPTE): <0.01% a 0 dRu output
Noise Floor: < -90 dBu
Dynamic Range: > 108 dB
Output Protection: Safe for short circuit or +25 Vdc
Channel Crosstalk,
Typical: -78 dB
Transient
Performance: Not limited by slew rate or power bandwidth under normal operating conditions, 20 to 20,000 Hz
Connector Type: Dual Octal plug with male centering post

Wiring: Channel 1:
Pin 1 = input (-)
Pin 2 = no connection Pin 3 = +15 Vdc
Pin 4 = chassis ground Pin 5 = -15 Vdc Pin 6 = input (+) Pin 7 = signal ground Pin 8 = low pass output
Channel 2:
Pin 1 = no connection Pin 2 = no connection Pin 3 = no connection Pin 4 = no connection Pin 5 = no connection Pin 6 = no connection Pin 7 = signal ground Pin 8 = high pass output
Power Requirements: -15 Vdc at 25 mA (supplied by amplifier)
Chassis Construction: Cold rolled steel
Dimensions
(see Figure 1): 2.75 in H x 3.58 in W x 1.25
in D
69mmHx91mmWx32rnmD
ALTEC LANSING continually strives to improve their products and performance. Therefore specifications are subject to change without notice.
Weight: 8.5 oz. 250 g



Next >>

 

CLICK ON ANY IMAGE TO VIEW THAT EQUIPMENT SECTION

aLTEC aMPLIFIER aCCESSORIES SECTION Altec Microphone section Altec Mixer Section  
Altec Powered Mixers and Misc
Altec Signal Processing sections
 
Specifications Catalog Table of Contents

 

 

 

CLICK ON ANY IMAGE TO VIEW THAT EQUIPMENT SECTION